Hi all,
Got a mates 320i here ... over the last few months it developed a starting issue ... would crank but would not fire but would eventually start.. It has recently refused to start at all.
A scan has revealed the following codes:
DME:
1) 2FDC interface (EWS -DME) despite being CAS
2) 2BC9 terminal 15 DME monitoring
3) 2C9E system voltage master DME relay
4) 3035 DME relay
CAS:
1) A0B4 starter system
1) I have swopped DME relays to no avail
2) I have determined that the relay is not getting a switching negative signal, presumably from CAS
3) Bypassing relay makes no difference
4) I noticed that when engine is cranking there is no engine speed being recorded
I am suspecting crank sensor amongst other things
What do the guru's think
Cheers
Andrew
Got a mates 320i here ... over the last few months it developed a starting issue ... would crank but would not fire but would eventually start.. It has recently refused to start at all.
A scan has revealed the following codes:
DME:
1) 2FDC interface (EWS -DME) despite being CAS
2) 2BC9 terminal 15 DME monitoring
3) 2C9E system voltage master DME relay
4) 3035 DME relay
CAS:
1) A0B4 starter system
1) I have swopped DME relays to no avail
2) I have determined that the relay is not getting a switching negative signal, presumably from CAS
3) Bypassing relay makes no difference
4) I noticed that when engine is cranking there is no engine speed being recorded
I am suspecting crank sensor amongst other things
What do the guru's think
Cheers
Andrew